Siemens VAI Metals Technologies is offering LD (BOF) steel works operators the Simetal Sublance 2.0, a new lance system for temperature and oxygen measurement, sample-taking and bath level detection.
The system consists of a vertically mobile sublance, including a lance car and a special probe magazine. It combines a compact, inherently operationally safe drive design with a radar-based measuring system for fast, precise positioning of the lance, which can achieve measuring cycle times of less than 110 seconds.
The system is simply and ruggedly constructed, resulting in higher reliability and lower
maintenance costs.
Because they are physically close to the converters in the steel works, sublances are exposed to severe environmental conditions, such as high temperatures and heavy concentrations of dust in the ambient air. This makes maintaining and servicing lance systems correspondingly difficult and expensive.
The new Simetal Sublance 2.0 from Siemens is designed for installation above the converter cooling stack. Measurements and samples are taken through a port in the stack. The drive system of the sublance is designed on the same principle as that of an elevator. Two redundant steel ropes fed over non-slip traction sheaves connect the vertically mobile lance car to a counterweight.
This is slightly heavier than the lance traveling device, so the device can be returned to its starting position in the event of a power outage or drive malfunction. This greatly increases operational safety. As only a low net weight has to be lifted, the drive motor can also have smaller dimensions, and the lance car can be moved more quickly and precisely than with conventional drive solutions. This facilitates measuring cycle times of just 110 seconds.
The lance car is equipped with multiple, adjustable rollers that ensure smooth motion along the guiding rails. The lance, together with the water supply, is automatically coupled by means of its own dead weight. Additional screws prevent accidental unhinging. The quick coupling enables the lance to be changed quickly and easily, as well as simply rotated through 180°. The lance can also be turned by hand to compensate for any thermal distortion.
A centering device is mounted at the lower end of the guiding rail to position the tip of the lance precisely, even at a high operating speed. The lance is positioned by means of a measuring encoder on the drive and a non-contact radar system. No additional position encoders are required on the rails themselves. This increases both the reliability and the safety of the system. All measuring sensors are mounted on the drive platform for easy access.
Siemens has also developed a new magazine solution for handling and holding the probes. The magazine has up to five storage boxes, each of which can hold 20 probes for long-term operation. vertical position by a special guiding rail. This turns the probe with the aid of its dead weight, and does not require any additional mechanical drives. Before mounting on the lance, the probe is fixated in a vertical position by a gripper, which also removes it after the measurement has been made.
A supplementary solution for automated calibration of the measuring system is currently under development. The Simetal Sublance 2.0 can also be combined with the Siemens LiquiRob robot system.